righthire.blogg.se

1. #SNAPPY TRAP WITH GARBAGE DISPOSAL INSTALLATION HOW TO#
2. #SNAPPY TRAP WITH GARBAGE DISPOSAL INSTALLATION CODE#

Push the discharge tube into place and tighten any nuts, clamps, or other fasteners to keep it in place. Slip the copper grounding wire over the green screw, then put the cover back on the housing. Connect them with the plastic wire connecters. Open the electrical housing and match the colored wires from the power supply to the ones in the garbage disposal. Insert a screwdriver into one of the lugs on the mounting ring and use it to twist the ring clockwise until it locks into place. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features NFL Sunday Ticket Press Copyright. Connects to a 1-1/4 in or 1-1/2 in sink drainpipe, tailpiece and to 1-1/4 in or 1-1/2 in wall.

#SNAPPY TRAP WITH GARBAGE DISPOSAL INSTALLATION CODE#

This product is in compliance with code IGC 328 by IAPMO.

All-in-one kit includes all parts needed. Insert the top of the new garbage disposal into the assembly and twist it to start threading it into the grooves of the mounting ring. Flexibility allows a range of adjustment to almost any angle. Screw the new mounting assembly into place beneath the sink. Hold it down with a heavy object for about 20 minutes while the putty dries. Available models: DK-100 Drain Kit for Single Bowl Kitchen Sinks, Bar Sinks, and Laundry.

#SNAPPY TRAP WITH GARBAGE DISPOSAL INSTALLATION HOW TO#

Apply a fresh ring of plumber’s putty and push the new flange into place. This video shows how to better accommodate the Snappy Trap when installing to a waste disposal. I encourage you to hire a plumber to make sure everything is done correctly and up to code in your area. Remove the old sink flange from your drain and clean up any adhesive residue. Theres an addon (might be in vanilla but idk) that. Pull off the old mounting ring and loosen the nut holding the old mounting assembly in place, then pull out the old mounting assembly. waste disposal interior and some of the dirt Another big Maxwell travel :) 1 / 12. Pinch the plastic wire connecters to disconnect the wires from the power supply. Unscrew the faceplate on the bottom of the unit to open the electrical housing, then slip the copper wire over the green screw. Disconnect the discharge tube that connects your garbage disposal to the ground plumbing, then twist the mounting ring at the top of the disposal clockwise to disconnect it from your drain. Before replacing a garbage disposal, switch off power to the unit at the main circuit breaker.